<article xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" article-type="Research Article" dtd-version="1.0"><front><journal-meta><journal-id journal-id-type="pmc">iarjet</journal-id><journal-id journal-id-type="pubmed">IARJET</journal-id><journal-id journal-id-type="publisher">IARJET</journal-id><issn>2708-5163</issn></journal-meta><article-meta><article-id pub-id-type="doi">https://doi.org/10.47310/iarjet.2022.v03i01.008</article-id><title-group><article-title>Abrasive Assisted Micro Electric Discharge Machining on ‘Inconel 718’: An Experimental Exploration</article-title></title-group><contrib-group><contrib contrib-type="author"><name><given-names>AshutoshKumar</given-names><surname>Pandey</surname></name></contrib><xref ref-type="aff" rid="aff-a" /></contrib-group><contrib-group><contrib contrib-type="author"><name><given-names>RajeevMani</given-names><surname>Tripathi</surname></name></contrib><xref ref-type="aff" rid="aff-a" /></contrib-group><contrib-group><contrib contrib-type="author"><name><given-names>TripathiAdarsh</given-names><surname>Satyendra</surname></name></contrib><xref ref-type="aff" rid="aff-a" /></contrib-group><contrib-group><contrib contrib-type="author"><name><given-names>SatyaPrakash</given-names><surname>Chaudhary</surname></name></contrib><xref ref-type="aff" rid="aff-a" /></contrib-group><contrib-group><contrib contrib-type="author"><name><given-names>AkshayKumar</given-names><surname>Mishra</surname></name></contrib><xref ref-type="aff" rid="aff-a" /></contrib-group><aff-id id="aff-a">Institute of Technology &amp; Management GIDA Gorakhpur, Uttar Pradesh 273209, India</aff-id><abstract>Micro Electric Discharge Machining (Micro-EDM) is an established machining process for making very small parts/components with accuracy and superior surface finish. The present work, investigates the abrasive assisted Micro-EDM of Inconel alloy with Tungsten electrode using Response Surface Methodology (RSM). The experiments were carried out based on RSM design of experiments, especially face center cubic design with and without magnetic field assistance on Micro-EDM processes. The machining parameters for experimental design are voltage; Pulse on time and feed rate each varying at three levels. Material Removal Rate (MRR) is the response parameter. Mathematical model was developed for prediction of MRR based on RSM methods. Analysis of variance was used to check the significance of model of MRR for both machining processes. The experimental observation shows that voltage, pulse on time and its interactions are significant on the MRR. The MRR of abrasive assisted Micro-EDM is 22% more than the MRR of non- abrasive assisted Micro-EDM.</abstract></article-meta></front><body /><back /></article>